BSOD: Memory_Management and IRQL_Not_Less_Or_Equal

I just recently built a new PC, and have been having problems with BSODs. I have been getting the Memory_Management error code most often, with a few IRQL_Not_Less_Or_Equal error codes mixed in. All my computer parts are brand new, and from what I can tell, all my drivers have been updated to the newest versions. I've run the Memory Diagnostic Tool, and it hasn't come up with anything, and same thing with sfc/scannow. Any help would be greatly appreciated.

• DESKTOP-E9NKLOU-Wed_10_12_2016_155241_40.zip (1.07 MB, 3 views)

Hi daltoncheck,

Welcome to the 10blog

Diagnostic Test

 RAM TEST

Run MemTest86+ to analyse your RAM. MemTest86+ - Test RAM - Windows 10 blog

   Note

MemTest86+ needs to be run for at least 8 complete passesfor conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zeroerrors here. Even a single error will indicate RAM failure.

Make a photo of the result and post it.

Addition:
If errors show up you can stop the test, remove all sticks but 1 and test this single stick in each slot for 8 passes or until errors show, switch sticks and repeat.
If errors show up and you see them a lot later, no problem, the errors don't affect the test.

Diagnostic Test

 DRIVER VERIFIER

   Warning

Please make a backup of your important files and get your rescue media or create one.
Please create a restore point.

Please follow this tutorialto run driver verifier.

Driver verifier stresses your drivers and will crash your pc if any driver fails due to a violation.

Driver verifier should be performed for a max of 48 hours, or when you have a bluescreen, whatever comes first.

If driver verifier has found a violation and you can't get back into windows normally, try to boot into safe mode and reset in safe mode driver verifier, or in the troubleshooting options open command prompt and type verifier /reset.

   Note

Your system will act very sluggishly while driver verifier is enabled, this is normal as your drivers will be being subjected to heavy testing in order to make them crash.

Please fill in your system specs

Please follow this tutorialand download the tool. The tool will give you detailed information about your system specs, please fill in your system specs more completely including PSU, cooling and other used stuff like mouse, keyboard, monitor, case, etc.
The PSU, cooling and other stuff are NOT mentioned in the tool.

In the left corner below in your post you find 'My System Specs'. After clicking it you can find a link a little below that says 'Update your System Spec', click on this link to get to the page where you can fill in your system specs.