BSOD ntoskrnl.exe+14d2e9

Cant understand which driver cause that BSOD

• debug -DESKTOP-433LSVD-27_03_2016_135048,42.zip (820.2 KB, 4 views)

Hi mrphua81.

Your motherboard says about its RAM support .....

- Supports DDR2 1066*/800/667/533 non-ECC, un-buffered memory

And all the four of your RAM modules are running at ......

Code:

Speed                         333MHz

That may be enough cause of your BSODs.

Either increase the RAM speed to at least 533, if possible; or get at least 4 GB of DDR2 RAM running at the required and supported speed by the motherboard.

See how it goes. Let us know.
___________________________________________________________

Code:

BugCheck A, {ffffe0010401e778, 2, 0, fffff803842ff349}  Probably caused by : ntkrnlmp.exe ( nt!KiInsertTimerTable+199 )  Followup:     MachineOwner ---

same error now ntoskrnl.exe+38cb5

Please do what stated in post #2.

I did it already... and it didn't help... got BSOD in 10 min after reboot in Dota2

If you report a BSOD, please provide the dump so that we can check and see what is going on.

Post a reply following the Blue Screen of Death (BSOD) Posting Instructions.

Here we go

• debug-DESKTOP-433LSVD-27_03_2016_165621,24.zip (939.9 KB, 2 views)

Your present RAM speed:

Code:

Speed                         200MHz

Before that, it was ....

Code:

Speed                         333MHz

Your motherboard supports .....

ASRock > K10N78D

Can your RAM run at any of those speeds? Make it sure. It it can, set those to any of those speeds.
If it cannot, change the RAM.

As far as you will not run the RAM with the speed that is supported by the motherboard, the BSODs will be there and before fixing it, troubleshooting cannot proceed.

I hope you understand. It is about hardware compatibility.

I set in Bios 400*800 due to RAM specification... whats next?

I set in Bios 400*800 due to RAM specification... whats next?

Sorry I failed to understand you. What actually have you done?