Problem solved as new hard drive is shown in this Pc

I have had to buy a new license as I cant use windows on hold drive but my new hard drive is not showing on This Pc,however when checking in the Bios it is listed. is this because there are no programmes on it.It is a New type Hybrid drive with no Jumpers on it ? I hope I have explained my problem properly.

Hello there,is a letter assigned to that drive?Check Windows explorer under manage...

I don't think the drive will show up in Windows Explorer, or have a drive letter assigned to it, unless it has been partitioned. If it's just a raw new drive it will only show up in bios. It should show up during the Windows install, however, at which time you can either manually partition the drive or allow Windows to partition it. If it is attached to the computer as a secondary drive, rather than the primary drive, you can access it, partition it, format it and assign a drive letter to the new drive in Windows Disk Management.

Go to command prompt and type diskpartthen list disk

Code:

Microsoft DiskPart version 10.0.10240    Copyright (C) 1999-2013 Microsoft Corporation.  On computer: KHB-HU04127    DISKPART> list disk   Disk ###  Status         Size     Free     Dyn  Gpt    ----  -----  ---  ---  -  -    Disk 0    Online          113 GB   618 MB        *    Disk 1    Online          931 GB   508 MB        *

then see if you can see your disk. Hopefully you can identify it by its size.

If so select it and display any partitions.

Code:

DISKPART> select disk 1 Disk 1 is now the selected disk.    DISKPART> list partition   Partition ###  Type              Size     Offset    -----  ------  ---  ---    Partition 1    System             200 MB    20 KB    Partition 2    Primary            600 GB   200 MB    Partition 3    Primary             99 GB   600 GB    Partition 4    Primary             44 GB   700 GB    DISKPART>

At this point you have either identified your disk and partition or not.

If you have just type select partition 2(or whatever number) and then assign letter=k(or whatever letter you want). You'll then be able to see it in file explorer.

Code:

DISKPART> select partition 2 Partition 2 is now the selected partition.    DISKPART> assign letter=k DiskPart successfully assigned the drive letter or mount point.    DISKPART>

If you cant see the disk with list diskthen your Windows can do nothing with it.
If you can see it but list partition shows nothing then you need to format it.

In any case post the results.

I don't think the drive will show up in Windows Explorer, or have a drive letter assigned to it, unless it has been partitioned. If it's just a raw new drive it will only show up in bios. It should show up during the Windows install, however, at which time you can either manually partition the drive or allow Windows to partition it. If it is attached to the computer as a secondary drive, rather than the primary drive, you can access it, partition it, format it and assign a drive letter to the new drive in Windows Disk Management.

Thankyou very much as your advice solved my problem I have installed my new license on my new hard drive and formatted the old one many thanks.